Your cart is empty

Info, CKRC Dual Mount Winch Plate For The Wraith.


It's Free!

Coming Soon.

(1) Mounting directions forin front of the grilleand/or highspeed racing:


A. Remove the winch mounting plate and fairlead from the winch.

B. Bolt the 3racing winch to the CKRC winch plate in the forward set of holes with the provided 2mm screws. The 3racing winches are not threaded inside and will require CA glue or loctite for these screws.


C. Next you will need to pull the front lights off and trim off the small tabs that lock the lights straight. You can bypass doing this if you want to drill 2 small holes into the CKRC plate instead.


D. Remove the 4 bolts that attach the front bumper assembly. Next slide the CKRC plate onto the TOP of the frame rails as shown.
The passenger side top of the winch will slightly hit the front bumper supports. It is optional to use a dremel and make a small groove so that there is no pressure on the winch body.
Bolt the front bumper section back on.


E. Bolt the winch plate on with the provided 3x12mm screws.


F. Install the supplied zip ties to mount the back side of the plate.

(Bottom mounting is shown.)

G. Cutting of the grille is required to finish mounting. At this time no body panel sets are available from axial, so we have no pictures to show how this is done. Its up to you. Measure twice, cut once.

That's it, wire in your winch and your done.



(2) Mounting directions forbehind the grilleand/orlow speed crawling:


A.Mount the winch to the CKRC plate with the 2mm nuts, 2mm screws and spacers provided. The screws should come up from the bottom of the CKRC plate, through a spacer, then the 3racing winch mount and finally into the 2mm nuts. Loctite isrecommendedfor these nuts.


B.Next you will need to pull the front lights off and set aside.

C.Remove the 4 bolts that attach the front bumper assembly. Next slide the CKRC plate onto the BOTTOM of the frame rails as shown.
Bolt the front bumper section back on.


D.Bolt the winch plate on with the provided 3x12mm screws and spacers. Going from the bottom the screws should come through the CKRC plate, then spacers, chassis, and finally the lights.


E.Install the supplied zip ties to mount the back side of the plate.


That's it, wire in your winch and your done.





Add to Cart:

  • Model: you cant buy free directions
  • Manufactured by: CKRC